Wurth Super Rtv Silicone Adhesive and Sealing Compound Black 200ml

SILSEAL-HTEMP-(SUPER-RTV)-BLACK-200ML

High-quality adhesive and sealing compound for use in industry and the automotive sector.

Excellent resistance to chemicals

• Can also be used in critical areas in which the seal comes into contact with various liquids
• Outstanding resistance to engine oil and transmission oil, refrigerant and anti-freeze agent

Non-acidic hardening system

• Non-corrosive, therefore has no negative impact on electronic components and on lambda probes

Sealant in compressed-air can

• Easy to dispense without additional aids
• The fine beads allow the product to be applied uniformly

Notice

When sealing e.g. oil pans and gearboxes it is vital that no sealant gets into the interior. For this reason we recommend to apply the sealant on a joining part surface. Join both parts and then carefully press by hand and lightly slide against each other. Afterwards separate the parts again and then remove the sealant that has gone inside. Join the components again within a max. of 5 minutes and tighten firmly. Before commissioning, observe the hardening time (depending on the sealant thickness).

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Instructions: Optimum adhesion to dry, clean and dust-free surfaces. The old sealant must be removed in full from the surface.

Colour: Black

Contents: 200 ml

Chemical basis: Neutral crosslinked silicones, oxime-based

Smell/fragrance: Characteristic

Min./max. temperature resistance: -60 to 260 °C

Max. short-term temperature resistance: 300 °C

Range of applications Water pumps Oil pumps Front cover Camshaft bearing cover Thermostat housing Oil pans Transmission cover Sunroof Doors

Density: 1.25 g/cm³

Min. skin-formation time: 5 min

Conditions for skin-formation time: at 23°C and 50% relative humidity

Full curing speed: 3 mm/d

Fully hardening/curing conditions: 23°C and 50% relative humidity

Shore A hardness: 30

Min. tensile strength: 2.2 N/mm²

Conditions for tensile strength: in accordance with ASTM D-412

Max. breaking elongation/conditions: 550 % / in accordance with DIN 53504

Heat conductance λ: 0.2 J/(m*s*K)

Heat conductance λ

conditions: in accordance with ASTM D-2214/70

Coefficient of thermal expansion: 0.0002 1/K

Coefficient of thermal expansion conditions: in accordance with ASTM EB-31

Dielectric strength: 16 kV/mm

Dielectric strength conditions: in accordance with ASTM D-149

Relative permittivity: 2.8

Conditions for relative permittivity: 1 MHz, ASTM D-150

Loss factor: 0.002

Loss factor conditions: 1 MHz, ASTM D-150

Specific volume resistivity: 1000000000000000 Ohm/cm

Conditions for specific volume resistivity: in accordance with ASTM D-257

**LEAD TIME indicated is an estimate only and subject to factory confirmation after order.