Betex Polyurethane No.60

Description An air-drying type modified alkyd resin based enamel varnish

Recommended Use

Suitable for decorative finish for wood surfaces Finish Gloss/ Matt Characteristics

• Easy Application
• Excellent abrasion resistance
• Good durability

Technical Data

Specific Gravity (25ºC) : 0.90 ± 0.10

Flash Point : 38ºC

Application Data

Application Method : Spray, Brush or Roller

Thinner : Turpentine

Thinning Ratio : 0 - 20 % by volume

Theoretical Coverage : Approx. 10 m²/L Dry Film

Thickness : Approx. 20 microns

Drying Time : Touch

Dry : Approx. 1 h

Hard Dry : Approx. 4 – 6 h Directions of Use Ensure surface is smooth, clean and dry.

Sand to ensure a smooth surface and remove any previous coating or treatment (e.g. wax or grease). Remove all dust from sanding.

Apply 2 – 3 coat(s) of Polyurethane Varnish No. 60. (with light sanding between each coat). Allow it to dry for at least 6 hours between coats.

Storage

Should be tightly sealed and stored in cool, dry place. Keep away from open flames.

Packaging

1L, 5L

Handling and Safety

As it contains solvent, the product requires special care in handling. Avoid any eye and skin contact.

For further information please refer to SDS.

Disclaimer

The information provided on this data sheet is not intended to be complete and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he/ she wishes to use it. As we have no control over the treatment of the product, the surface preparation, application or other factors affecting the use of the product, we are not responsible for its performance, nor would we accept any liability whatsoever or howsoever arising from the use of the product. The information contained in this data sheet may be modified by us from time to time, and without notice, in light of our experience and product development.