Injector Height Gauge Kits for Detroit Diesel Engine series 50 60 3350

-This injector Height Gauge Kit is for Detroit Series 50 and Series 60 engines. Similar to J-42749, J-45002, J-39697, J-42665, J-35637-A
-Set injectors during installation and at set service intervals on Detroit Series 50 and Series 60 engines.
-Includes 78.2mm, 78.8mm, 80.3mm, 81.0mm and 82.1mm gauge blocks along with knurled handle that allows for block to be used at 90° angle for use in areas with restricted access.
-Constructed with high quality solid steel has an unparalleled lifespan which is much better than others. Black Power Coated Surface, Anti-corrosion/Rust Paint.
-Be sure the height gage seats on the machined surface with the tip in the pilot hole. Adjust the height until you can slide over it and find that slight drag.

Feature:
Injector height gauges are used to properly set injector body height to the injector follower for proper fuel injector timing. Incorrect injector timing can cause engine power issues, poor idle quality and fuel mileage issues.

Applications:
For Size: 78.2mm, Series: 60, Engine: DDEC I, Year: 1986-1993.
For Size: 78.2mm, Series: 60 & 50, Engine: DDEC II, Year: 1986-1993.
For Size: 78.8mm, Series: 60 & 50, Engine: DDEC III, Year: 1994-1997.
For Size; 80.3mm, Series 60 DDECIII Late 1997.
For Series 60 & 50 DDECIV 1997-1998.
For Sizes 81.0mm Series 60 & 50 DDECIV 1998- 1999.
For Series 60 Marine 2000- 2003.
For Size 82.1mm Series 60

Package Included:
A set of Injector Height Gauge

Note:

1. Delivery can be expedited with additional freight cost

2. Stock availability/ Actual order lead time will be rechecked once confirm order

3. We do not accept returns or exchanges due to Indent item unless product quality issue

4. Picture shown is for illustration only, actual product may differ

5. This image is representative of the product range, actual product may differ

6. Product may vary slightly from image representation

7. Please allow 1-3mm error due to manual measurement